ASSEMBLING & OPERATING
YOUR ASH VACUUM
ATTENTION! The vacuum accessories are packed inside the vacuum tank.
UNPACKING YOUR VACUUM
Remove the entire contents of the carton
, please note that the accessories are
packed inside the vacuum tank. To access these accessories, undo the latches (A)
Fig.3 on both sides of the tank, remove the tank cover/motor assembly (B), then
remove the accessories inside the tank (C).
WARNING!
DO NOT CONNECT THE POWER CORD TO THE POWER
SOURCE UNTIL THE FOLLOWING ASSEMBLY AND SET-UP INSTRUCTIONS
HAVE BEEN DONE.
INSTALLING FILTER
Before reinstalling the cover/motor assembly on, make sure the included HEPA
cartridge filter (A) Fig.4 is installed as shown. If the HEPA cartridge filter is not
installed, it must be installed before use, simply press it up over the motor cage as
shown. Reposition and secure the cover/motor assembly to the tank with both
cover latches.
INSTALLING HOSE & ALUMINUM NOZZLE
-FOR VACUUMING MODE
1) Attach one end of the hose (A) Fig.5 to the vacuum inlet port (B), secure the
hose by inserting and turning it clockwise inside the inlet port.
2) Attach aluminum nozzle (C) Fig.5 to the other end of the hose (D).
FIGURE 3
FIGURE 4
FIGURE 5
