Kinetik TD2 Series, Руководство пользователя

Страница: 10 / 28

9
Using your TENS Pain Reliever
1. Make sure the unit is switched off.
2. Attach the gel pads to the output cables as above and insert into the respective sockets, channel A and
channel B.
3. Attach the gel pads to the area of pain. Please revert to the ‘Positions for use’ (Gel Pad Positioning)
section on page 14.
4. Turn on the device using the ON/OFF switch and the letter "A" will flash on the display, indicating that
the left output (channel A) can be adjusted. Press the "+" and "-" buttons to increase and decrease the
intensity of channel A.
5. To adjust channel B, press the "A=B" button once. You will see the letter "B" start to flash indicating that
channel B can now be adjusted. Press the "-" or "+" buttons to increase or decrease the intensity of
channel B.
6. Press the "M" button to cycle through the different modes. Each mode has a different waveform, select
the waveform that best diminishes the pain being treated.
7. At any time you may press the central " II" to pause the device (press again to resume).
8. Press and
hold
the central " II" button to increase the treatment time by 10 minutes. Repeat to select
treatment periods of from 10 to 60 min.
9. When done, switch off the device and put away the connecting wires and electrode pads.
Note:
Always start from the lowest intensity, and then gradually adjust to a comfortable level.