Using your Blood Pressure Monitor
14
Memory
The memory can store 90 sets of measurements and will additionally calculate the average (mean) of the
last three readings. The results will be automatically stored.
To check the memory, press the MEM button (either just after a measurement has been taken or while
the unit is off). The unit will show the average of the last three readings. Press the MEM button to scroll
up or the SET button to scroll down through the individual memories.
Note that the most recent measurement is always stored in memory slot 1. Once all 90 memory slots are
filled, the oldest memory will be erased during the next measurement to make room for the latest
memory.
Deleting the Memory
With the unit off, press the MEM button to switch the unit on then press and hold the SET button for 4
seconds. Press the SET button again to alternate between ‘DEL NO’ and ‘DEL YES’. Confirm by pressing
the START/STOP button.
The above procedure will delete the entire memory bank, not just a single measurement.
Once deleted, the memory cannot be recovered.
