Initial Start-Up
General Instructions
Insert the Batteries
Open the battery door in the back of the scale.
Remove insulating strip from beneath the battery (if
fitted) or insert batteries (1 x 3V CR2032) observing the
polarity signs (+ and -) inside the battery compartment.
* The digits “8888” will be shown on the LCD.
Close the battery door and wait until the digits “0.0kg”
are shown on the LCD.
The Kinetik Wellbeing Body Analyser applies BIA (Bio-impedance Analysis) technology. A
small amount of weak current flows through the human body so as to detect the
bio-impedance and estimate BMI, body fat, total body water, muscle mass and bone mass.
The electrical current is small and may not be felt.
This BIA technology is safe, non-invasive, toxic-free and harmless.
The current mentioned above is less than 0.5mA. However, please be aware that anyone
with a wearable or implantable medical electronic instrument, such as a pacemaker, must
avoid using this device.
The intended use of this device is for healthy children 10-17 years old and healthy adults.
CAUTION
When the symbol “ Lo ” appears, the device will power off after about 4s. Then you shall replace with a
new set of batteries.
Worn batteries are hazardous waste. Do NOT dispose of them together with the household garbage.
Please refer to the local ordinances and recycling instructions regarding disposal of the worn batteries
and scrapped device.
If you do not intend to use this unit for a prolonged period of time, it is advisable to remove the batteries
before storing.
The Body Analyser Scales BCA1 supports multiple users (Up to 8). You may follow
below instructions to assign User ID and set up your own profile, including Gender,
Stature, and Age.
Initial Start-Up
Set Up Your Profile
1. After confirming Gender, the system will divert to Height setting automatically.
2. As pictured below, the digits “165” blinks. The user can press the function key
or to increase or decrease the numeral.
3. You may press and hold the function key or to quickly change the numerical.
4. Press “set” key to confirm Height.
1. After confirming User ID, the system will divert to Gender setting automatically.
2. As pictured below, the portrait blinks. The operator may press the function key
or to select Gender.( Male/Female Athlete/Male Athlete/Female )
3. Press “set” key to confirm Gender.
1. With batteries correctly installed, press “set” key to enter setting mode when the
scale is off. Or when the LCD displays 0.0, long press and hold “set” key to enter
setting mode.
2. The system will request User ID selection first. As pictured below, “P1” blinks. The
operator may press the function key or to select User ID among P1 to P8.
3. Press “set” key to confirm User ID.
1. Assigning User ID
2. Setting Gender
3.Setting Height
Athlete Mode:
An athlete is considered as a person who does 10 hours or more per week of aerobic activity
and has a resting heart rate of 60 beats perminute.These individuals should select Athlete
Mode for the most accurate measurement results.The Body Analyser Scales are not calibrated for
professional athletes or body builders.
