1.
Unfold the frame
assembly
(Part A)
and position
as shown.
kinetic assembly
2
4.
Slide the spring (Part D) over the L-bolt.
5.
Tilt the resistance unit up towards the frame while
directioning the threaded end of the L-bolt into the
hole in the yoke. Attach the adjustment knob (Part E)
and washer, turning clockwise a few turns to keep the
resistance unit in the upright position.
2.
Position the resistance unit (Part B) as shown here and
attach it to the frame using the mounting bolt (Part F).
Insert the mounting bolt into the square hole first, then
attach the nut.
Note:
Because we test each trainer there
will be tire marks on the roller.
PLEASE NOTE:
Before attaching your bike to the trainer,
make sure the bike tires are inflated to the proper pressure.
Mountain bikes can be used on the trainer; but keep in mind
that the knobby tires cause additional noise and vibration.
Dual compound tires are not recommended for use on the
trainer. A wide slick tire will improve the friction between
the tire and roller and is recommended for best trainer
operation.
3.
Place the non-threaded short end of the L-bolt
(Part C) into the frame sleeve as shown here.
Part A
Folding
Frame
www.kurtkinetic.com
877·226·7824
