3.1.2. Installation in the table cut-out
Screw the 4 mounting plates
2
on with matching screws (not enclosed).
Adjust the
3
holding angles
4
at the basics module approximately to the tabletop thickness minus 2–3 mm at the basic module,
loosen the 4 panhead screws with spring discs
5
slightly for this and adjust the two holding angles
4
and the
4 adjustment screws
6
accordingly.
Insert the basic module from below between the fastening bolts of the flat frame.
Caution: Do not pull the moving cable flap from above to keep it from bending.
Attach the two holding angles
4
to the tabletop from below with at least 3 suitable screws each (e.g. Ø 3.5 or Ø 4 mm,
possibly with washer; not enclosed). Now pull the basic module over
the 4 adjustment screws
6
evenly and only hand-tight towards the
flat frame, so that the heights of the flaps are precisely aligned with
the flat frame.
Caution: Do not over-tighten the adjustment screws
6
to keep the
aluminium frame from bending.
Tighten all screws well
5
.
Dimensions of the installation space under the table (here 4-fold, with installed cable duct; 6-fold width is 324 mm)
140
150
250,
5
234
103,
5
183
First insert the flat frame
1
in the cut-out and align it.
Attach the flat frame to the table section from below as sketched with the enclosed 4 mounting plates
2
, 4 threaded screws
7
M3 x 25 or M3 x 40 (depending on tabletop thickness), using the respective washers
8
and nuts
9
.
3
4
5
6
3
2
1
2
7
7
2
8
9
