Kinderkraft ONETO3, Руководство пользователя

Страница: 31 / 120

31
•
The back of the seat must rest flat against the back of the car seat. Please make sure that
the headrest dues not create an unwanted space between the car seat backrest and back
seat of the vehicle. Some car headrests constitute an obstacle to the installation of a car
seat and must therefore be disassembled first.
•
The adult safety belt buckle must not be located too close to the bottom of the child seat
armrest. If in doubt about this issue, contact the child seat manufacturer.
•
You should give your child a good example and always fasten your belts. An adult with
unfastened safety belts may also be a threat to the child.
•
Before each trip by car, make sure that the seat is properly secured.
•
The car seat must be protected even when not in use. Unattached seat can cause injuries
to passengers even during emergency braking.
4. Securing your child
4.1 Seat cushion
NOTE The seat cushion (C) should be used for very small children. The cushion improves
comfort and provides additional support for very small children.
4.2.1 Adjusting the straps
Loosen the harness straps by pressing the release button (F) and pulling the harness as much
as possible.
Remember! Do not pull the shoulder pads.
4.2.2 Headrest height
Press the colour button located on the top of the headrest.
• For weight group I, the headrest has six different height positions not requiring removal of
the shoulder straps.
ATTENTION: The appropriate shoulder strap height should see the strap enter the backrest
just above the child’s shoulders. Make sure that the shoulder straps are appropriately
adjusted to the child’s shoulders.
• The remaining four positions for weight groups II and III can be set after the shoulder straps
are removed and the harness is hidden (see point 6.1).
ATTENTION: The shoulder strap should run between the child’s shoulder and neck. The
headrest should be appropriately adjusted to the child’s head.
4.2.3 Backrest tilt mechanism
The backrest tilt can be adjusted with the lever (K). Pull the lever and slide the seat. Release
the lever in the desired position. Gently move the seat around until you hear a clear “clicking”
sound – this means that the seat in secured in the selected position.
4.3 Securing the child with the harness
• Loosen the harness straps as much as possible by pressing (F) and pulling the harness straps.
Never pull by the shoulder pads!
• Release the buckle (D) and place the harness s traps on the sides of the seat. Place your child
in the seat.
• Adjust the headrest to the child’s height (see point 4.2.2).