Kinderkraft NESTE UP, Инструкция по эксплуатации

Страница: 32 / 88

32
1. List of baby cot components - page 3
1 Side frame x2 6 Crossbar
2 Cot material 7 Mattress
3 Main frame of the cot 8 Carrying Bag
4 Middle support of the cot's bottom 9 Fastening straps
5 Side bracket in the cot padding
2. Mounting of the cot:
Prepare an appropriate surface to avoid damaging the product during assembly. Connect the
side frames (1) with the main frame (3) of the cot (figure A)
– you’ll hear a “click” if it's
assembled correctly (figure B). Slide the material (2) onto the exposed areas of the side frame
(figure C). Place the material onto the tube of the main frame and fasten the zipper (figure C1).
CAUTION! Remember to secure the zipper to prevent opening (figure D). Connect the tube of
the drop-down side to the top part of the frame (figure E) and secure using the zipper on both
ends (figure F).
CAUTION! Remember to secure the zipper to prevent opening (figure G). Slide
the ends of the side bracket (5) in the cot padding material into the relevant openings in both
side frames (figure H).
Next, connect the bracket to the legs of the cot by sliding it in along both
sides into the relevant openings (figure H, I). You’ll hear a “click” if it's assembled correctly. Place
the cot on the side opposite to the drop-down side. Slide the bar (6) into the legs and make sure
that the latches on both sides are secured (figure J). Place the cot back in the vertical position.
Connect the bottom bracket (4) to the legs of the cot, and slide it in along both sides until it
locks
– you’ll hear a distinctive “click” when this happens (figure K). Affix the bottom bracket (4)
to the base of the cot using three small hook-and-loop closures (figure L). Slide the material of
the cot over the bottom bracket, and affix with a large hook-and-loop closure (figure M). Wrap
the hook-and-loop closures around the brackets on the side of the cot (figure N). Place the
mattress in the cot. The assembled product is shown in figure O.
3. Height adjustment:
The cot is adjustable to 5 different heights. To adjust the desired height hold the cot with your
foot, move button A sideways while pressing button B and adjust the frame of the cot to the
desired height (fig.P).
4. Bedside cot:
To connect the cot to the parents' bed, remove the safety devices at the locks (fig. R). Unlock
the zips on both sides (fig. S). Slide the lever and slide out the tube of the side panel (fig. T).
Repeat on the other side. Remove the side panel of the cot (fig. W) and pull the tube out of it.
Adjust the height of the cot to the parents' bed (fig. U). Fasten the buckle of the fastening straps
to the cot (fig. X). Interleave the straps either through the whole bed or only through its side
bar (fig. Y) and adjust so that the cot is fixed securely to the parents' bed (fig. Z). Roll the loose
parts of the straps (9) under the cot. To move the cot as close as possible to the base of the
parent's bed, move button A sideways (fig. AA) and at the same time press button B. Move the