The ceramic fuel bed remains hot for a considerable period after use and
sufficient time should be allowed for the fire to cool before cleaning etc.
The fire must only be operated with the Black Magic trim supplied with the product.
OPERATING THE FIRE
The controls are located behind the ashpan cover which is situated behind the
Ashpan / Fender. The controls, comprise a control valve to adjust the gas flow, a
flame control lever to adjust the look of the flame picture and a push button piezo
igniter. To light the fire proceed as follows:-
1)
Depress the control knob and turn anti-clockwise to the position
marked pilot. Hold in the control knob for a few seconds to allow the gas to
reach the pilot.
2)
Continue to hold-in the control knob and press the igniter button. If the pilot
does not light, continue to press the igniter button until ignition occurs. The
pilot flame’s reflection can be seen by looking at the left hand side front of
the trim. When the pilot has lit, continue to hold the control knob in for 5-10
seconds to allow the thermocouple to heat up, if the pilot goes out when the
control knob is released, repeat the lighting sequence.
In the unlikely event of a failure of the igniter, the fire can be lit as follows :-
Depress the control knob and turn anti-clockwise to the position
marked pilot. Hold in the control knob for a few seconds to allow the gas to reach
the pilot. Insert the tip of a lit taper in behind the front ceramic coal formation on
the left hand side. This will light the pilot flame. When the pilot has lit, continue to
hold the control knob in for 5-10 seconds to allow the thermocouple to heat up, if
the pilot goes out when the control knob is released, repeat the lighting sequence.
3)
After lighting, turn the control knob in the anti-clockwise direction to the high
position and the main burner will light.
4)
The gas control can be turned clockwise from the maximum position to give
the desired heat output and the flame control adjusted to give the most
pleasing flame effect or maximum glow.
WARNING
If the fire goes out for any reason or is turned off and it is
necessary to re-light the fire it is important to allow the fire to cool
for 3 minutes before attempting to re-light it.
4
