5
TEMPERATURE & SAFETY PROTECTION:
•
INTERNAL OVERHEAT PROTECTION: The charger has a built-in overheat and an
overload electronic circuit. This protects the charger from being damaged if overheated
or overloaded and will automatically decrease the charging current. Once the units in-
ternal temperature decreases to a safe level, the charger will resume normal charging.
•
SAFETY TIMER PROTECTION: The charger has safety timers for every stage. If the
battery Voltage doesn’t reach a certain Voltage within a certain time, the unit will stop
charging as it’s highly likely that you’re attempting to charge a severely discharged or
heavily sulphated battery. If any of the stages time out, the charger will immediately
stop charging in order to protect the battery. This will be indicated with the fault LED
flashing slowly.
•
REVERSE POLARITY: The charger has reverse polarity protection. If the charger output
leads are connected reverse polarity, the fault LED will come ON and the charger will be
disabled. Simply unplug the charger from AC power and then connect the output leads
to the correct polarity.
• SHORT CIRCUIT PROTECTION: The charger will automatically turn OFF if the output
leads are short circuited and the fault LED will come ON. This prevents the charger from
being damaged if the positive and negative crocodile clips or the optional ring terminals
accidently touch each other while the charger is turned ON.
•
ECO MODE: This Kincrome Battery Charger has a built in ultra low power consumption
circuit. If AC power is connected and the battery is disconnected, after 10 seconds the
charger will automatically go into an ECO mode. During this mode the power drawn
is less than 0.36W which totals 0.01kWh per day power consumption. If AC power is
connected and the battery is connected, once the battery is fully charged and during the
long term maintenance stage, the total power consumption is around 0.03kWh per day.
Both the selected Charge rate and Battery type LED’s will flash GREEN to indicate ECO
mode.
BATTERY TYPES & CAPACITY:
•
Suits 12V conventional lead acid batteries (VRLA) AGM, Calcium, Gel & Wet.
The Ah (Ampere Hours) capacities shown below are to be used as a general guide only.
Some batteries may be able to handle a higher charge current. Refer to the battery
manufacturers specifications and recommendations for your charging requirements.
Charge Rate:
1A
8A
12A
Charging
3 - 20Ah 24 - 160Ah 36 - 240Ah
Maintaining
< 100Ah
< 240Ah
<360Ah
SMART 9-STAGE BATTERY CHARGER
& REJUVENATOR
12V 12 AMP
ELECTRICAL PARTS & ACCESSORIES:
AC Power Cord:
1.8m with SAA 3 Pin AU Plug
DC Output Lead:
1.2m with quick connect plug
Charging Leads:
Quick connect 60cm Crocodile Clip Harness
KP87005 manual_OC1206U_OC1212U_Troy.indd 4
29/03/2018 3:57 PM
Quick connect 60cm Ring Terminal Harness
