15L WET & DRY SHED VAC
5
WET & DRY SHED VAC USER INSTRUCTIONS
KP701- 15L POLY TANK
ASSEMBLY
Remove all of the vacuum components from the box and dispose of all the packaging
materials thoughtfully and as per your local council guidelines
1.
Connect the 3pce extension wand pieces
(2)
together to create the vacuum wand.
2.
Insert the lower vacuum hose
(3)
connector into the vacuum hose inlet connector
(6)
and secure the hose by twisting the hose connector a ¼ turn in a clockwise direction (Fig 1a).
3.
Insert the bent upper vacuum hose connection coupling into the top of the 3pce
extension wand
(2)
(Fig 1b).
4.
Locate the appropriate vacuum tool onto the lower section of the 3pce extension wand
(2).
CHOOSING THE CORRECT VACUUM FILTER
THE KP701 15L WET & DRY VACUUM COMES WITH TWO FILTER TYPES.
Foam Filter:
The foam filter
(16)
can only be installed when you are using the vacuum to clean up
spills or when water is present where you are vacuuming. The foam filter
(16)
is designed to prevent water splash-back within the vacuum tank
(11)
from entering the
motor head
(12)
during operation.
CAUTION: DO NOT USE FOAM FILTER IN DRY VACUUMING APPLICATIONS.
Cloth Filter:
The cloth filter
(17)
can be installed for all general vacuuming applications
where water is not present. This cloth filter
(17)
can be continuously used for many years
as it is a cleanable & washable accessory.
CAUTION: DO NOT USE CLOTH FILTER IN WET VACUUMING APPLICATIONS.
Note: You MUST NOT use more than one filter type at a time.
• Using more than one filter type at a time can cause damage to the vacuum cleaner motor potentially leading
to premature failure of the product. - Failure of the product due to using more than one filter at a time is not
covered by the manufacturers warranty.
• Regular cleaning of the filter is required to maintain optimal suction of the vacuum. Failure to clean the filters
regularly can lead to damage of the vacuum and or poor performance of the product. Premature failure of the
product or poor performance of the vacuum is not covered by the manufacturers warranty and can be
considered abuse of the tool.
INSTALLATION OF THE FILTERS
Remove the vacuum head
(12)
from the vacuum tank
(11)
by releasing the tank retention clips
(10)
on the side of the vacuum. Install the correct filter type for your application as follows
Foam Filter (16)
Wet Vacuuming: Slide the foam filter
(16)
over the filter basket
(15) (fig 2a)
until the filter is located
over the filter locating rings on the underside of the
motor head
(12) (fig 2b).
Cloth Filter (17)
Dry Vacuuming: Locate the cloth filter
(17)
onto the upper top ring of vacuum tank
(11) (fig 3).
Once located ensure that the filter is pressed into the
vacuum tank
(11)
so the motor head
(12)
can be installed
correctly
(fig 4)
.
(Fig 2a)
(Fig 2b)
(Fig 3)
(Fig 4)
( Fig 1a)
(Fig 1b)
