IMPACT WRENCH
5
WARNING:
Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains
chemicals known to cause cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
Caution:
When not in use, ensure the tool is switched off and unplugged from the mains power and place the tool on its side on a
stable surface where it will not cause a tripping or falling hazard.
The impact wrench’s electric motor has been designed for the means of 240V AC only.
Always check that the power supply corresponds to the voltage on the rating plate. 240 V AC means your tool will operate on
alternating current.
Extension Cords
Caution:
Use only extension cords that are approved by the country’s electrical authority. Before using extension cords, inspect them
for loose or exposed wires, damaged insulation and defective fittings. Replace the cord if necessary.
It is recommended that power cords do not exceed 25m in length. Longer than 25m can result in power drop and damage of your tool.
Description of Symbols
The following symbols are shown on the tool:
The impact driver is intended for indoor
use only.
/IPM
Impact rate per minute
Your impact driver is double insulated;
therefore no earth wire is required.
/min
Revolutions per minute
Read the instruction manual before use.
V
Voltage
Regulative Compliance Mark
~
Alternating Current
WARNING
Hz
Hertz
N
M
Newton Meters / Torque Rating
Содержание KP201
Страница 8: ...IMPACT WRENCH 8 www kincrome com au...
