kincrome K16003, Руководство пользователя

Страница: 13 / 25

Installation—K16006, K16007
13
Step One: Disconnect pump from power supply
Step Two: Disconnect inlet and outlet fittings from pump
 Slide red QC clips open on the inlet and outlet ports of the pump.
 Pull inlet and outlet fittings out of the pump.
 Loosen hose clamp on outlet hose and broadcast hose and remove 1/4" NPT x
3/8" straight HB fitting from outlet fitting.
 Do not disconnect inlet hose from inlet fitting.
Step Three: Remove pump from sprayer
 Remove four screws from pump mounting feet.
 Remove pump from sprayer.
Step Four: Assemble fittings to regulator
 Remove steel clips from outlet
and bypass ports of regulator.
 Install QC x 3/8" HB fitting
into bypass port of
regulator. To insert quick connect
fittings, lubricate O-ring with water
and twist fitting while inserting into
pump port. Secure with steel clip.
 Thread 1/4" NPT x 3/8" straight
HB fitting (removed from outlet
fitting in Step Two) into 1/4"
NPT port on front side of
regulator (the side of the regulator
with the “BYPASS” label).

Thread pressure gauge into 1/4"
NPT port on back side of regulator.
 Install QC x 3/8" HB elbow fitting
into outlet port of regulator. To
insert quick connect fittings,
lubricate O-ring with water and
twist fitting while inserting into
pump port. Secure with steel clip.
Step Five: Assemble regulator and fittings to pump
 Install inlet port of the regulator into outlet port of the pump. Slide red QC clip
closed.

Turn regulator to orient knob toward the top of the pump.
Step Six: Drill hole in tank
 Align the four circles on the supplied drill template sheet with the pump mounting
holes on the sprayer tank.
 Using a 9/16" drill bit (not included) drill a hole through the top of the tank in the
position indicated by the appropriate X on the template.
 Remove plastic debris from inside the tank (if chemicals have been used inside
the tank, refer to pg. 18 step 4 for personal decontamination after removing
debris).