kincrome K13350, Инструкция по эксплуатации

Страница: 3 / 8

2
1/4” AIR REGULATOR
1) Service
a. Tool service must be performed only by qualified repair personnel.
b. When servicing the regulator use only identical replacement parts. Use only authorized parts.
c. Use only the lubricants specified by the manufacturer.
2) Safety Warnings
WARNING! This product is specifically designed for compressed air service ONLY. Use with any other material
(liquid or gas) is a misuse of the product and not permitted.
Use with hazardous liquids or gases (such as oxygen, alcohol or liquid petroleum gas) will harm the regulator and
may result in an explosion. Misuse will void all warranties and manufacturer’s responsibilities.
Note: This 1/4” Air Regulator is a part of a high pressure system and the following safety precautions must be followed at all
times along with any other existing safety rules. Read this instruction manual before installing this device to the air supply
system. Be thoroughly familiar with the controls and the proper use of the equipment.
a. Safety glasses must be worn during operation.
b. Always work in a well ventilated area.
c. Do not exceed any pressure rating of any component in the system.
d. Protect air lines from damage and/or punctures.
e. Check air hoses for weak or worn condition before each use. Make sure all connections are secure.
f. Keep all nuts, bolts and screws tight and ensure equipment is in safe working condition.
g. Refer to compressors instruction manual for additional safety instructions and advise.
3) Unpacking
1. After unpacking the Kincrome 1/4” Air Regulator, carefully inspect the unit for any damage that may have occurred during transit,
check for loose, missing or damaged parts.
Note: Make sure all fittings, bolts, bowls etc are tightened before putting the regulator into service.
2. Ensure all packaging materials are disposed of as per your local council guide lines.
4) Assembly
Assembling the Mounting Bracket to the Air Regulator
1. Remove the retaining nut (5) from the 1/4” Air Regulator, by turning it anti-clockwise.
2. Once the retaining nut (5) has been removed, feed the mounting bracket (6) over the air regulator knob (7).
Note: The mounting bracket (6) should point towards the roof.
3. Secure the mounting bracket (6) to the 1/4” Air Regulator by refeeding the retaining nut (5) over the air regulator knob (7)
and turn clockwise.
Assembling the Pressure Gauge to the Air Regulator
1. Remove the pressure gauge (3) from its packaging and apply Teflon Tape to the thread of the pressure gauge (3), to assist
in a leak free seal.
2. Catch the thread of the pressure gauge (3) to the 1/8” BSP located on the front face of the 1/4” Air Regulator, and
turn clockwise.