2
5) Operation
CAUTION:The information in this manual is to be read in conjuction with the air tool, the accessory is being fitted to. No responsibility is assumed
for inaccuracies or for liability arising out of the application and use of the equipment described.
1. Refer to the air tool manual for connecting/setting up the air tool which the needle scaler will be used on.
2. Remove the needle scaler from the box (Fig.1), screw the needle scaler onto the threaded end of your air hammer (do not over tighten) (Fig.2), then tighten it
securely with the 3 grub scews, using a 4mm hex key (not supplied) (Fig.3).
3. Once the needle scaler has been securely fastened, gently squeeze the trigger and move slowly along the workpiece. Do not push down on the scaler; let the
tool do the work.
Note: Regularly check for worn or damaged needles. If the needles are damaged or worn replace with Kincrome replacement needle pack K13258-1.
4. When you are finished, turn off the air supply and then hold the needle scaler a safe distance away from yourself and others. Squeeze the trigger of your
aim hammer to bleed off the remaining air. Then, disconnect the air hose.
Warranty
Warranty given by Kincrome Australia Pty Ltd of 3 Lakeview Drive, Caribbean Park, Scoresby, Victoria (Tel 1300 657 528).
The applicable warranty period (24 months) commences on the date that the product is purchased. If this product has materials or workmanship defects (other than defects caused by abnormal
or non warranted use) you can, at your cost, send the product to place of purchase, an authorised Kincrome service agent or one of Kincromes addresses for repair or replacement. Your rights
under this warranty are in addition to any other rights you have under the Australian Consumer Law or other applicable laws. Our goods come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. For further details please visit www.kincrome.com.au or call us. Due to
minor changes in design or manufacture, the product you purchase may sometimes differ from the one shown on the packaging..
IMPORTANT!
If the tool fails to operate correctly, call customer service on 1800 657 528 for advice on the best resolution for your situation. If a resolution cannot be achieved over the phone
please take the tool and all related accessories to an authorised service centre or place of purchase showing proof of purchase for assistance.
Note: Needles are a consumable item, and therefor are not covered by warranty.
Remove Needle Scaler from packaging.
Fasten Needle Scaler to Air Hammer.
Tighten hex bolts with 4mm hex key.
Completed assembley.
(Fig. 1)
(Fig. 2)
(Fig. 3)
(Fig. 4)
