Kimex 049-3W Series, Руководство пользователя

Страница: 17 / 28

Do not touch projection
surface with hands.
Do not use chemical
cleaning agents to clean
the projection surface.
Do not write or draw on
projection surface.
Do not disassemble the
screen.
Use a soft cloth or brush
to clean the projection surface
.
Use water and a soft
cloth to clean the screen.
Misuse of the screen may cause damage to the screen or
injury to persons.
Warning
To prevent damage to the screen and injury to persons,
the screen must be mounted correctly and securely.
Do not hang things from the screen or climb on it. Doing
so may cause the screen to fall off and damage the
screen and cause injury.
Retract the projection surface back into the case after
use. This will protect it from dust and dirt, and prevent it
from loosening.
Do not disassemble the screen. Doing so may damage
the screen and cause the screen fabric to fall down. If the
screen needs repairing, contact the dealer from whom
the screen was purchased.
14
The flatness adjustment of screen surface
The flatness of the screen has adjusted to its perfect place before it was sold out
from factory, but for the factors of temperature, transportation and long time use, the
surface will has some slight changes. In order to make sure the flatness of the screen,
some adjustments needed. The methods are as below:
1. Showed as Pic. 1, adjust the knob to adjust the tightness of the strings.
2. Showed as Pic.2, adjust this screw clockwise with a screwdriver, then the fabric
will pulled to each end of the bar, then the fabric will become flat again.
Pic. 1
Adjusting knob
Pic. 2
Note: The screen may be operated as frequently as necessary but
should not be lowered and raised continuously. Doing so will cause
the motor to overheat and power to cut off. If this happens it will be necessary
to wait until the motor has cooled down sufficiently to resume operation.