Canopy
®
1
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part 3020964, Revision
-
Assembly Instructions
Bench Base Assembly
Tools Required
•
Box Cutter/Utility Knife
•
Cordless Drill w/#2 Phillips head bit drive
•
M4 & M5 Allen key/drive
(optional, supplied in box)
Hardware Required
2
-
Bench Base
(28FBFBSEP***)
2
-
Rectangle Worksurface
(28W28**RT**)
1
-
Tray 2 or 4
(optional)
1
-
Ganging Tray
(optional, needed if 2 bases attach together)
8
-
M6 X 12 Flat Head Machine screws
40
-
M6 X 12 Button Head Machine screws
Installation
Note: Bases installed 1st, trays 2nd, fixed screens 3rd and
tops 4th and worksurface screens 5th.
1.
Using a knife open box removing all components carefully
and place aside. See components in
Figure A.
2.
Open legs as shown in
Figure B
and lift base out of box
setting on a non
-
marring surface.
3.
Slide mounting blade into base tubes following
steps 1
-
3
for both sides.
Step 4
, use M5 Allen wrench key/drive for
securing blade using mounting screws.
See Figure B.
4.
Repeat steps 2 & 3 for second base setting aside.
5.
Lift 1st base and set upright, sliding all 4 tubes over U
-
brackets as shown in Figure D.
Note: Tubes with holes go
on top and tubes without holes go on bottom. Face
countersink holes to the inside of base.
Slide second base
onto U
-
brackets. Attach base using M4 Allen wrench and
counter sink screws on face side and button head screws on
bottom side of tubes.
See Figure D.
Figure A
Figure B
Power Cord
Hardware
Box
Up/Down
Switch
(2)
Mounting
Blades
Figure C
Figure D
(4) Tubes
Tray 2
Tray 4
Ganging
Tray
Counter Sink
Screws (face
of tube)
Button Head
Screws
(bottom of
tube)
Step 1
Step 2
Step 3
Step 4
