Systems Assembly Instructions
Xsite
®
Page 1 of 2
Door Kit for Fold Down Tile
Caution:
Store all tiles flat until installed. Do not stack on top
of tiles.
Tools Required
■
Tape Measure
■
#10 Phillips Screwdriver Bit
■
Cordless Drill/Driver
■
Channel Locks or Pliers
List of Kit Contents
1 Door
6 #10-24 Pan Head Bolts
2 Pivot Arms
4 #10-24 Hex Nuts
2 Pivot Brackets
2 #10-24 Lock Nuts
4 Nylon Washers
1 Magnetic Catch
2
3
/
16
" Pushnuts
2 #6 x
1
/
2
" Screws
Installation
1. If adding to an installed tile, remove tile by lifting up and
tilting out at bottom. (Figure A).
2. On each pivot arm pin, install one #10 flat nylon washer.
Engage each pivot arm pin into slot on each side of door.
Place pushnut over pin and press on with pliers or channel
locks. Repeat for opposite pushnut and pin. (Figure B).
3. With curve of pivot bracket down, align holes in bracket
with bottom two holes on inside of tile. From inside of
tile, insert two #10 x
1
/
2
" Phillips pan head bolts through
bracket and tile side. Install two #10-24 hex nuts to bolts
and tighten. (Figure C).
4. Insert pivot shaft on door into hole on attached pivot
bracket. (Figure C).
5. Slide remaining pivot bracket over pivot shaft on opposite
end of door. Repeat step 3 for pivot bracket attachment
on other end.
Figure A
Figure B
Figure C
#10 Flat Nylon
Washer
Fold Down Door
Pivot Arm
Pin
Pivot Arm
Pushnut
Storage Tile
Pivot
Bracket
#10-24 Phillips Pan
Head Bolts
#10-24
Hex Nuts
Pivot Shaft
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 2019612 Revision A-06
