Systems Assembly Instructions
Footprint
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part No. 1741505 Revision A-04
Page 2 of 3
Installation (continued)
3. Position the cabinets in their leveled and desired location.
To slide cabinets right or left, lift the lower front edge of
each cabinet, thus lifting the cabinet away from the panel
face(s). Open the cabinet doors and fully slide them back.
Press the adjacent cabinets together by pushing horizontally
and slightly lifting the front edge of each cabinet. The
cabinet ends must be in direct contact with no gaps.
(Figure C).
4. Continue pushing and slightly lifting the cabinets. Loosely
position the ganging bracket under the lower front flanges
of the cabinet so that the vertical “ears” of the ganging
bracket are directly behind the edge of the lower front shelf
flange. (Figure D).
5. With the ganging bracket in position, press the bracket
upward to its final fully-seated position. Significant pressure
will be required as the bracket “ears” are intended to
grip the interior end panels of the cabinet, aiding in
positioning/holding power of the assembly. A rubber
non-marring mallet may be needed to fully seat the bracket.
(Figure E).
Figure C
Figure D
Figure E
Ganging bracket “ears”
engage both cabinets
Cabinets must be
in direct contact
with no gaps
Ganging bracket
pressed into position
