Systems Assembly Instructions
Footprint
®
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part No. 1741505 Revision A-04
Page 1 of 3
Lunar Overhead Storage
Cabinet Ganging Bracket
for Xsite
®
/Traxx
®
Tools Required
■
Electric Drill/Driver
■
Rubber (non-marring) Mallet
■
#3 Phillips Head Bits
Package Contents
■
1 Ganging Bracket
■
2 #10 x
¹⁄₂
" Self-drilling
Phillips Panhead Screws
Installation
Note: This instruction covers installation of ganging brackets
for all Lunar cabinetry assembled and installed on Xsite and
Traxx only. All operations to assemble the cabinet and doors
can be done by one person, but it is recommended that two
people install the units to the panel system/Traxx.
Important: This instruction explains basic Lunar ganging
bracket assembly techniques. Please see assembly instruction
“Lunar Overhead Storage, Flipper Door Cabinet” for basic
cabinetry assembly and installation to panel systems as
needed.
Purposes of the ganging bracket:
■
To align the front lower edge of the adjacent cabinet.
■
To add rigidity to the installed cabinets.
Figure A
Figure B
Pre-installation action: As mentioned above, reference
assembly instruction “Lunar Overhead Storage, Flipper Door
Cabinet” to assemble all cabinetry and install it to Xsite panels
and/or Traxx. Take care to not damage the unit(s) or the
panel. Inventory the package contents before proceeding with
assembly/installation. Stop if there are insufficient items to
complete the assembly.
1. Figure A shows a single door Lunar overhead cabinet for
reference.
2. Figure B shows a typical side-by-side application for
ganging on an Xsite panel run.
