Kimaldi BioMax2, Инструкция по установке и программированию

Страница: 66 / 91

BioMax2 / KBio2-Online
Installation and Programming Manual
www.kimaldi.com Page 66 of 91
Function: Enables the detection LED of the optical barrier This command can be used to
allow for biometric identification simply by placing a finger on the sensor.
The optical barrier is self-managed by default; therefore this instruction is useful to:
• Activate biometric identification after reading a proximity card.
• Force the fast recovery of the optical barrier after a biometric identification (the
normal recovery time is set using the CFG-UI_OPT_T_GUARD Byte of the
configuration, see
Subsection 8.1.3.
or is indefinitely suspended using the
Disable optical barrier
instruction).
9.6.24. Disable optical barrier
Function: Disables the detection LED of the optical barrier There are several reasons for
using this instruction:
• When the scanning of a finger print has started to prevent new warnings.
• In the case of 1:1 identification, the user is expected to start identification using the
proximity reader.
• In the case of presence control, the user is expected to press F1 or F2 prior to
biometric identification.
Response
OP 0x4A
NA 0x0001
ARG Status of the optical barrier
Instruction
OP 0x4C
NA 0x0000
ARG None
Response
OP 0x4C
NA 0x0001
ARG Status of the optical barrier