41 of 56
Revision 4
KiloVault
®
LLC • 330 Codman Hill Road, Boxborough, MA 01719 • +1 (888) 218-5924 •
• www.kilovault.com
Screen Slider Switch. The status should change to "No charge or
discharge.”
Figure 20: KiloVault® HAB™ V4 iT Basic Screen Slider Switch
•
KiloVault® HAB™ V4 firmware updates take about 10 minutes.
•
Firmware updates are usually timed to take place during the evening in
North America.
•
Depending on what part of the BMS is being updated, either the red
“ALARM” LED will flash by itself, or the red “ALARM” LED will flash
along with the two bottom red LEDs in the State of Charge bar.
•
Firmware updates include BMS improvements to:
o
KiloVault® HAB™ V4 to KiloVault® HAB™ V4 Communications
o
Cycle Counting
o
State of Charge Calculation
o
Other BMS functions as needed.
•
The WiFi adapter firmware cannot be updated.
5.4.
Starting the KiloVault® HAB™ V4 for the first time
1.
Turn on (close) the inverter main DC breaker. If your inverter does not
have its own power switch, and if completing the circuit between the
