6
Manual / Function
1.
Full auto shut-off screwdriver
It stops automatically when the screw has been tightened up and reached the set-up torque level. The
device will not cause damage of task since no continue running after screws are tightened.
(1) Trigger switch
The LED lights on when the trigger switch has been pressed about one-third down, and then the
screwdriver starts functioning when the switch trigger has been pressed half way down; on the
contrary, it stops when the screw has been tightened up or the trigger has been released.
(2) Forward / Reverse switch
When the switch turn to the right as arrow indicates, the screwdriver will be clock-wise screwing to
tighten things up; Vice versa, left switch means to release the screw. As the diagram showing, always
set the switch to neutral position when the screwdriver is not being used.
Forward (screw) Reverse (unscrew)
(3) LED light
While press the trigger, the LED lights up automatically to assist the job to be done; on the contrary,
it will be off once the trigger has been released.
(4) Bit Sleeve
Switch the screw bit and compatibility, pull the head of the type B screwdriver, and install the bit
according to the diagram below, after installing the bit please also install the W type cap and push it
in following the arrow indicated on the diagram below on diagram #2.
Diagram 1 Diagram 2
Pull the bit holder
Insert the bit into
Insert the sleeve
