Kikusui TOS5050, Руководство по эксплуатации

Страница: 44 / 139

Chapter 4 DESCRIPTION OF FRONT AND REAR PANEL ITEMS
4-6
2. Reset from PASS status (status that the
PASS
message 30 appears)
The Tester will reset from the PASS status and act as follows:
(a) Lets the
PASS
message 30 disappear.
(b) Turns OFF the PASS signal fed through the SIGNAL I/O connector
37
.
3. Reset from FAIL status (status that the
FAIL
message 31 appears)
The Tester will reset from the FAIL status and act as follows:
(a) Lets the
UPPER FAIL
message 31 disappear.
(b) Lets the LOWER FAIL message
31
disappear.
(c) Turns OFF the U FAIL (upper fail) signal fed through the
SIGNAL I/O
connector 37 .
(d) Turns OFF the L FAIL (lower fail) signal fed through the SIGNAL I/O connector
37
.
4. Reset from PROTECTION status
The Tester will reset from the PROTECTION status and act follows:
(a) Lets the
PROTECTION
message 32 disappear.
(b) Turns OFF the PROTECTION signal fed through the
SIGNAL I/O
connector
37
.
However, the Tester will not reset from the PROTECTION status if the interlock pins of
the
SIGNAL I/O
connector
37
are open or if the high voltage supply section is overheated
in DC test (for TOS5101 and TOS5051 only). If this is the case, eliminate the interlock
signal (For detail refer to Section 6.3.3 “Interlock Function”) or wait until the Tester cools
off and then reset from the PROTECTION status with the
STOP
switch
3
.
5. Reset from READY status (status that the READY message
28 appears)
The Tester will reset from the READY status and act as follows:
(a) Lets the READY message
28 disappear.
(b) Turns OFF the READY signal fed through the
SIGNAL I/O
connector
37
.