Kikusui PFX2515, Руководство по эксплуатации, Страница: 50 / 104

50
PFX2512_CE
Turning On and Off of the Power Supply
There is no specific order to turn on the power of equipments in the system (the PFX2512, DC
power supply, Electronic load, and other peripherals that compose the system), and also there is no
order for when turn off the power of equipments.
Confirm safety, then turn on / off of the power.
Turning on of the power switch
1
Confirm that the connecting cables between the equipments and the power
cables are correctly connected.
2
Turn on the POWER switch of the connected DC power supply and the
Electronic load.
p. 38 , p. 39
Confirm that protection functions and an external analog control of each equipment
are being set properly. When the Electronic load unit is connected in the parallel
operation, assign the master unit and the slave unit.
3
Press the front-panel POWER switch so that it is on (the I position).
4
Check the firmware version on the screen.
All of LED's on the front panel Illuminates for a few seconds, then only the "POWER/
STANDBY" LED stays to be illuminated.
Few seconds after the firmware version is displayed, the channel number will be
displayed for few seconds. After the channel number is displayed, the voltage value
will be displayed.
It becomes in the POWER state, so the order from the BPChecker3000).
p. 16
When you turn the POWER switch on for the first time after purchase, the PFX2512 starts with its
factory default settings.
p. 54 , p. 95
When the "ALARM/WARNING" LED Illuminates, the occurrence of alarm or the activation of
protection function may be concerned.
See
Few seconds later
Example for model ID 7101
Example for firmware version 1.00
Example for channel address1
Few seconds later
See
See