Kikusui PFX2000 Series, Руководство по эксплуатации

Страница: 23 / 104

PFX2000 Setup 1-7
1.3 Precautions When Moving the Product
When moving the product to the installation location or when transporting the unit,
note the following points.
■
Turn off the power switch.
Moving the product while the power is turned on can cause electric shock or dam-
age to the unit.
■
Remove wiring.
Moving the product with the cables connected can cause wires to break or injuries if
the product is dropped.
■
When transporting the product, be sure to use the original
packing materials.
Otherwise, damage may result from vibrations or from the product falling during
transportation.
1.4 Connecting the Power Cord
This section describes the connection of the power cord of the unit frame.
The power to the control unit is supplied through the USB; you do not have to con-
nect the power cord to it.
•
Have a quali fi ed engineer connect the power cord.
• To prevent the possibility of electric shock, turn off the switchboard (the
switch that cuts off the power supply from the switchboard) before con-
necting the cord.
• Connect the product to the power source by keeping the distance between
the product and the switchboard switch under 3 m. By doing so, you will be
able to easily access the switch in a case of emergency.
If the distance must be greater than 3 m, provide a separate switch within
3 m from the product. Use a two-pole switch that cuts off L and N wires
simultaneously.
• Inside the product, protective circuits including input fuses are connected
to match the polarity of the input terminal. Make sure the colors of the
wires connected to the corresponding input terminals (L, N, and
(GND)) are correct.
WARNING
CAUTION