Kikusui PBZ20-20, Руководство пользователя

Страница: 42 / 170

42
PBZ
Selecting the DC Signal (Internal Signal Source)
This section explains how to configure the PBZ to generate the internal signal source’s DC
voltage and current. Set the voltage in CV mode and the current in CC mode. If you set the
soft start time and the soft stop time, the soft start and soft stop features will be enabled.
p. 87
Depending on the settings, there are two setup screens. Press the DC key to switch between
pages (page 1/2 and page 2/2). If you have used to set SELECT (the signal source
selection) to EXT (an external signal source), pressing the DC key will have no effect.
1
Press DC.
The DC key illuminates, and the DC setup screen (1/2) appears.
2
Press DC to select the page that you want to edit.
The page switches.
3
Use the up and down cursor keys to select a setting.
The cursor moves to the setting that you want to specify. You can switch the page by
continuously pressing the up or down cursor key.
4
To enter a number, use the left and right cursor keys to move the cursor
to the digit that you want to specify.
This operation is unnecessary if you are using the numeric keys.
5
Use the rotary knob or numeric keys to specify the value.
p. 72
If you fix the value that you specified using the rotary knob, the input value is
confirmed. If you are using the numeric keys to specify the value, press ENTER to
confirm the input value.
6
To specify other settings, return to step Procedure 2.
7
To set up other features, press a key other than DC.
The DC key turns off. The DC setup completes, and the PBZ switches to the feature
for the key that you pressed.
Voltage, Current, and FINE Settings (Page 1/2)
See
CONFIG
See
t
0
Output
DC setting
FINE setting
(+)
(-)