Kikusui PAT160-25T, Руководство по эксплуатации

Страница: 98 / 218

6-4
PAT-T 4kW
6.1.2 Connection (Parallel Operation)
Up to five units including the master unit (up to four slave units) can be connected.
Connecting the signal wires (parallel operation)
Fig.6-4 and Fig.6-5 shows an example when connecting two slave units.
If you are using the optional parallel operation power cable (PC01-PAT), you can
use it immediately as it is already assembled.
Fig.6-2 Optional parallel operation po w er cable (PC01-PAT)
p. 5-3
If you are using the J1/J2 connector kit that comes with the package, refer to Fig.6-4
to make the connection. For tools needed for the connection, see Table 5-1.
At the factory shipment, the protection socket is attached to the J1/J2 connector.
Keep this protection socket and be sure to attach when the J1/J2 connector is not
used. If the protection socket is damaged or lost, contact Kikusui distributor/agent.
Fig.6-3 Protection socket
Possible electric shock.
•
The J1/J2 connector contains pins that are at the same electric
potential as the output terminal. If you are not using the J1/J2
connector, be sure to insert the protective socket provided.
• Be sure to use the protective cover on the sockets.
Fig.6-4 Connection for parallel operation (t w o slave u nits)
1
Choose the po w er s u pply that is to be the master u nit.
See
[ 8 4-49-0110]
WARNING
J2 J1 J2 J1
Sla v e unit 1 Sla v e unit 2 Master unit
I SUM IN
D COM
SHUT DO W N
D COM
OUT ON/OFF CONT
PRL IN COMP
PRL IN –
PRL IN+
11
12
13
14
24
25
26
J1
11
12
13
14
24
25
26
11
12
13
14
24
25
26
11
12
13
14
24
25
26
11
12
13
14
24
25
26
10 10 10 10 10