Kikusui PAN 110-1.5A, Руководство по эксплуатации

Страница: 55 / 160

PAN-A 3-11
Chap
.3
Basic Oper
ation
1
Using the OUTPUT terminal board on the rear panel
• For safety, turn off the POWER switch when connect-
ing the load.
• After connecting the load cable, mount the rear out-
put terminal cover.
• To assure a good connection of the load cable to the
output terminals, use crimped terminals.
For the model 175W user, see Fig.3-3.
For the model 350W, 700W, or 1000W user, see Fig.3-4.
MODEL 175W
Fig.3-3 Connection to the OUTPUT terminal board
on the rear panel (model 175W)
As shown in Fig.3-3, lay load cables at the left of the OUTPUT termi-
nal board, as seen from the rear panel.
WARNING
CAUTION
When the terminal board is
not used, fix the terminal
cover using the lower hole.
OUTPUT
terminal board OUTPUT
terminal board
Crimped terminal
on the load cable