3
Attach the terminal block to the panel using
the M3 screws provided with the terminal
block.
4
Attach the panel to the chassis using the M3
screws.
5
Attach the terminal cover to the terminal block
using the M3 screws.
For your safety, if you are not using the terminals, attach
the terminal block to keep the terminals covered.
6
Connect the G terminal of AC LINE OUT on
the TOS3200 rear panel to the G terminal of
the panel terminal block of this product using
the white cable.
Use the terminal block screws.
7
As same as step 6 , connect the N terminals
together using the white cable, and connect
the L terminals together using the black cable.
Be sure the polarities are correct.
8
Attach the terminal cover provided with the
TOS3200 to AC LINE OUT.
9
Attach the panel to the rack using the M5
screws and washers.
Outline drawing
M3 screw
(2 locations)
M3 screw
(3 locations)
Panel
Terminal
block
Terminal cover
M5 screw
(4 locations)
Washer
(4 locations)
M3 screws (supplied with the TOS3200, 2 locations)
Fix the cover in place using the holes on the bottom side.
G: Cable (white)
N: Cable (white), L: Cable (black)
LNG
L
N
G
When the terminal cover is attached using
this hole, the terminals are not exposed.
If you connect wires to the terminals, use
this hole to attach the terminal cover.
・
The instrument may fall.
Install the suitable support angles
applying to the used rack system to
support the instrument.
CAUTION
Support angle
Instrument
463 (18.23)
482 (18.98)
37.5 (1.48)
132 (5.20)
57 (2.24)
480 (18.90)
255.1 (10.04)
289 (11.38)
255.1 (10.04)
289 (11.38)
460 (18.11)
24.5 (0.96)
100 (3.94)
149 (5.87)
KRA150-TOS (for JIS racks)
KRA3-TOS (for EIA racks)
Unit: mm (inch)
KIKUSUI ELECTRONICS CORP.
1-1-3 Higashiyamata, Tsuzuki-ku, Yokohama, 224-0023, Japan
Tel: +81-45-482-6353
Fax: +81-45-482-6261
www.kikusui.co.jp/en
