Kikusui KHA3000, Руководство по эксплуатации, Страница: 87 / 392

4
KHA3000
87
Language, I/F Setting and Buzzer
System
Setup
Direct setting for the buzzer volume
You can directly set the buzzer volume. Arrows are indicated beside number keys 1 and 0 on
the operation panel. The up arrow turns up the volume and the down arrow turns down the
volume. These keys cannot be used during testing or analysis. Press the
“ SHIFT + 1 ” keys to
turn up the volume, or press the “ SHIFT + 0” keys to turn down the volume.
Updating information for options
p. 65
This product automatically recognizes any optional current sensors connected to the EXT
CLAMP terminals when the power is turned on. Whenever any current sensor is replaced or
newly connected with the POWER switch already turned on, press the Update Opt.
Information key to make the system recognize the sensor as the system will not automatically
recognize the connection. If any current sensor connected to the system has not been
recognized, a dialog message to prompt the operation to make the system recognize the
current sensor (i.e., pressing the "Update Opt. Information" key) will be presented when the
"Curr Input Terminal" menu is selected or when the test is started. If the power is turned on
again after the current sensor is connected, the current sensors connected will be
automatically recognized.
No. Menu item Description Default
1 Language Select the language in which menus are to be displayed. From the
second power-on, the system starts with the language used when the
POWER switch was turned off previously. English
2 I/F Select Select the type of interface (I/F). USB
3 GPIB Address Enter the GPIB address in the range from 1 to 30.
Enter the value with the numeric keypad and press the ENTER key, or
use the large knob to increase or decrease the value.
Turn off the POWER switch and turn it on again to enable the setting. 1
4 RS232C Baudrate Select the RS232C baudrate.
Turn off the POWER switch and turn it on again to enable the setting. 19200 bps
5 Return Terminates I/F Setting. –
6 Buzzer Volume Specify the buzzer volume in the range from 0 to 8.
Enter the value with the numeric keypad and press the ENTER key, or
use the large knob to increase or decrease the value. 4
7 Return Terminates buzzer setting. –
8 Update Opt. Information Check and update the connection status of current sensors. The check
results will be displayed in the option information field of the System
Setup screen.
–
9 Prev/Next Page 1/3 Switches to another menu page. –
F key: Function key. You can also use the ESC key to return.
See