Kikusui KHA3000, Руководство по эксплуатации, Страница: 208 / 392

208
KHA3000
Setting Test Conditions (61000-3-3)
Set the test conditions in the Vf-Test Conditions List display. When the test condition setting is
complete, switch to the Vf-Observation and Analysis display for observation during the test.
Setting a Limit Value Standard
1
Press the Vf key.
The Vf-Test Conditions List display appears.
2
Select test conditions.
p. 267
To use the same conditions as for a test that was executed in the past, call up a test
condition file and use it.
3
Press the F6 key to select menu page 1/4.
4
Press the F1 key to select Limitation Standard.
Select IEC 61000-3-3 (Pst Auto) or IEC 61000-3-3 (Manual).
5
Press the F2 key to select Measurement Technic Standard.
Select IEC 61000-4-15 Ed2.0 for measurements based on the IEC 61000-3-3 Ed3.1
standard. you can measure Tmax and other parameters according to IEC 61000-3-3
Ed3.1.
Select IEC 61000-4-15 Ed1.1 for measurements based on earlier than the IEC 61000-
3-3 Ed3.1 standard.
6
Press the F6 key to switch to another menu page and set other test
conditions.
Optimizing the Current Range
1
Press the VIEW key.
p. 79
The Vf-Observation and Analysis display appears.
2
Press the F1 key to select List in View Type.
Measured values are displayed in the form of a list.
3
Press the VIEW key.
The Vf-Observation and Test Conditions display appears and the menu for setting the
measured values, which are still listed, is displayed.
4
Change the operating conditions of the EUT to maximize the input
current.
5
Press the F6 key to select menu page 4/4.
6
Press the F1 key to select V/I Range Setting.
A sub-menu is displayed.
7
Press the F1 key to select Ch. Setting (V/I Range).
p. 192
When "Linked" is selected in the Channel Linkage menu, independent setting of L1, L2,
and L3 cannot be made.
See
See
See