6
HP01A-TOS/HP02A-TOS
Component Names and Functions
No. Name
Description
1
Red Area
This part holds the contact pin to which high volt-
age is output.
2
Contact Pin
High voltage is delivered to this pin. The pin
emerges from the red area when you depress the
slide lever. The test probe is used with this pin
contacting a test point of the DUT.
3
Start Switch 1 (trigger)
This is used to begin testing. Depress the trigger
while grasping the test probe grip with the fingers
of your dominant hand.
4
Start Switch 2
This is used to begin testing. Press the switch
with a finger from your non-dominant hand. This
hand should be free, since the other hand holds
the test probe.
5
H.V ON LED
This red LED indicates that high voltage is being
applied to the contact pin. It turns on or off in
response to the on/off status of the DANGER
(TEST ON or H.V ON) lamp of the Tester.
6
Grip
Grasp this part to use the test probe. Grasp with
your dominant hand.
7
Slide Lever
Depressing this lever causes the contact pin to
emerge from the red area. Be sure to depress it with
the fingers of the hand grasping the test probe grip.
8
Remote Control Cable
Connect to the REMOTE terminal.
9
High Voltage Cable (red)
Connect to the high voltage terminal.
10
LOW Test Leadwire (black)
Connect to the LOW (GND) terminal
5
6
7
1
2
3
4
9
8
10
