Kiepe Elektrik SEG, Руководство по эксплуатации

Страница: 44 / 72

44
SEG Operating Instructions
6 Maintenance
6 Maintenance
6.1 Overview of maintenance 6.2 Tools required
Standard workshop equipment is adequate for working
on the pull-rope emergency stop switch. At the very least
you will require the following tools for maintenance:
•
Set of screwdrivers (slot / Phillips)
•
Open-end wrench for screw connection M25
•
Suitable torque wrench (Section 4.2: „Electrical con-
nection“, page 24 and Section 4.3: „Tightening
torques“, page 26)
interval Component Measure
Monthly
1
1. It may be necessary to reduce the interval depending on the
operating or local conditions (e. g. greater quantities of dirt,
weather conditions).
Pull-rope emer-
gency stop switch Visual inspection (see
Section 6.3, page 45)
Cleaning the device
from the outside
(see
Section 6.4, page 47)
Annual Pull-rope emer-
gency stop switch Functional test (see
Section 6.5, page 50)
Every 3 years Pressure equaliza-
tion element ( 15 )
2
2. Optional fittings
Replacing the pressure
equalization element
(see Section 7.6, page
61)
Every
20 years Pull-rope emer-
gency stop switch Replace pull-rope
emergency stop switch
(see Chapter 5: „Mount-
ing and dismounting",
page 31)
Fig. 6-1: Installation position of the pressure equalization el-
ement
10
2
11
15
1 4