INSTALLING THE BATTERIES
This product uses 3 “AAA”/ LR03 batteries.
Please follow the illustrations on installing the batteries correctly.
Batteries should be inserted and removed by an adult.
To install the batteries :
1.
Use a suitable screwdriver, unscrew and remove the battery cover
located on the underside of the unit.
2.
Insert 3 x AAA batteries into the compartment ensuring they are
installed the correct way. The polarities are marked inside the battery
compartment. Should the batteries have no polarity marking, the
positive end has a bump on the end.
3.
Reassemble the battery cover and tighten the screw to secure. Do not
over tighten.
GETTING STARTED
WARNING:-All packing materials such as internal bags, plastic collars,
plastic films, carton inserts are not part of this product and should be
discarded for your child’s safety.
To start playing with the push’n go crab, just press on its shell and watch it
move sideways while a tune is played. Its claws open and close while the
Crab moves. Look at its googly eyes spinning!
There are 3 different tunes and 3 different funny sounds when the shell is
pressed.
TROUBLE SHOOTING
If the unit doesn’t operate…
Check that the batteries are installed
correctly.
If the volume is too low…
Install new batteries.
If there is a continuous
buzzing sound and the unit
doesn’t operate…
Install new batteries.
If the sound begins to play at a
very high or low rate of
speed…
Install new batteries.
If the unit malfunction…
Reset the unit.*
•
To reset the unit, remove the batteries and re-insert them back in
again.
CARE AND MAINTENANCE
1.
Keep the unit clean by wiping it with a slightly damp cloth.
2.
Keep the unit out of direct sunlight and away from any direct heat
source.
3.
Remove the batteries when the unit is not being used for an extended
period of time.
4.
Do not expose the unit to moisture or water.
POWER SUPPLY
Batteries: 3 x 1.5V “AAA” / LR03
Do not use rechargeable batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
Do not mix old and new batteries.
The unit will go into standby mode after a period of inactivity. The system
automatically awakens if you press it.