KIDWELL RIMBA, Руководство пользователя

Страница: 10 / 16

10
To unfold the seat, release the locknut (Fig. 2.1), lift the seat up and rotate it 180 degrees
around the handlebar post. With the seat in position, lower it along the handlebar post all
the way down to stop and secure it with the locknut. The last step is to pull the seat to the
horizontal position (Fig. 2.3).
UNFOLDING THE SEAT
2
The rear wheel mudguard is a brake. Step on the mudguard to start braking.
CAUTION: Stepping on the brake with the whole body weight while the scooter is
moving quickly may result in a sudden stop, loss of balance, and injury!
BRAKING
6
The scooter can be turned by turning the handlebar to the left or the right as needed.
The handlebar post should not twist in the tube.
STEERING
5
Fold the scooter by folding the seat in the reverse order of the seat unfolding procedure
shown above. With the seat folded and in front of the handlebar, release the handlebar
post lock by pressing the yellow release button (Fig. 3.1) and pulling the handlebar post
up and holding it in place.
With the handlebar all the way up, you can fold the scooter. With the handlebar parallel
to the ground, it will lock itself to prevent unfolding.
Adjust the handlebar post height by releasing the nut directly below the handlebar (Fig.
4.1). Next, press the lock pin (Fig. 4.2) into the handlebar post to clear the locating
hole and slide the handlebar post up or down towards one of the height levels until the
locking pin pops back into a locating hole on the side of the handlebar post.
Fully secure the handlebar post after this adjustment by retightening the nut below the
handlebar.
CAUTION: With the handlebar post height adjusted to the child, make sure that the
lock pin extends from the locating hole. This means the handlebar post height lock is
engaged. Remember to retighten the lock nut.
FOLDING THE SCOOTER
HANDLEBAR ADJUSTMENT
3
4