assembly
Parts list
A 1 x seat unit
B 2 x front wheels
C 2 x rear wheels
D 1 x toybar
E 6 x friction strips
F 1 x frame
Wheel assembly
Turn the frame upside down and
push the wheels into the
corresponding holes in the base.
Ensure the wheels are fully inserted.
Fig 1
Friction strip assembly
Align the stems of the friction strips
with the corresponding holes in the
base and push fully in. Please note
that the outside stems are different
sizes. Make sure the thinner stem is
pointing towards the base.
Fig 2
Seat assembly (back)
Turn the frame back onto the wheels
and lift the top tray up until it clicks
into place.
Fig 3
Thread the straps onto the back of
the seat unit through the slots in the
tray recess.
Fig 4
Now, from the underside, pull the
straps and the buckles completely
through and pivot the buckle 90° so
it lies flat against the underside of
the tray. Fig 5
Seat assembly (front)
To secure the front of the seat, slot
the right hand pin into the front of
the seat, then the left hand pin. Push
inwards and towards the right.Fig 6
The central pin should automatically
locate into the hole. Now push the
pins inwards and downwards to
secure all three pins.Fig 7
IMPORTANT!
Please refer to the
“Additional Safety Checks” leaflet
supplied before using the walker for
the first time.
Toy bar assembly
Clip the toy bar onto the edges of
the top tray where the ridges are.
Fig 8
Height adjustment
Turn the red height adjustment lever
90° anticlockwise with your thumb
and index finger.Fig 9a + b
Pull your finger towards you in a
downward motion. This will release
the lock and enable you to choose
one of the different height
positions.
F
ig 9c
NOTE
- Always remove your child
from the walker before trying adjust
the height.
TIP
-You may find it easier to place
your feet on the walker base when
adjusting the height.
A
B
C
D
E
F
Fig 6
Fig 7
Fig 8
Fig 9a
Fig 9b
Fig 9c
Fig 2
Fig 1
Fig 3
Fig 4
Fig 5
