Kidde VM-REMICA, Инструкция по установке

Страница: 1 / 4

P/N 3101795-EN • REV 02 • ISS 11JAN16 1 / 4
VM - REMICA Remote Paging
Microphone Installation Sheet
Description
The VM - REMICA provides remote paging capability throughout a
building or campus. Each VM - REMICA has two inputs for connecting
other remote microphone units. The paging circuit supports up to
63 interconnected remote paging stations.
Installation
WARNING: Electrocution hazard. To avoid personal injury or death
from electrocution, remove all sources of power and allow stored
energy to discharge before installing or removing equipment.
Caution: Circuit boards are sensitive to electrostatic discharge (ESD).
To avoid damage, follow ESD handling procedures.
To install the VM-REMICA:
1 . Remove the top retainer bracket on the back of the inner door on
the VM - RLCM remote annunciator cabinet. See Figure 1 .
2 . Loosen the nuts on the bottom retainer bracket.
3 . Insert the VM - REMICA behind the bottom retainer bracket, and
then tighten the nuts on the bracket.
4 . Reattach the top retainer bracket to the inner door to secure the
top of the VM - REMICA.
5 . Set jumpers JP1 and JP2 as follows:
• Position A if AUDIO_OUT is connected to an EAEC
• Position B if AUDIO_OUT is connected to another
VM - REMIC A
Wiring
Wire the VM - REMICA as shown in Figure 2 .
Notes
• All wiring is supervised and power - limited.
• Test EOL resistors are installed on the remote microphone key
inputs to prevent trouble signals during installation. When
connecting field wiring to a next VM - REMICA, remove the resistors
from pins 12 and 13, and 16 and 17 on TB1.
• Remote microphones cannot be cascaded more than six deep on
a single circuit path.
• Install a 1 .8 kΩ EOLR when key in is not used.
Testing
Note: Additional hardware may be required to adjust the microphone.
To adjust the microphone:
1 . After the system amplifiers are properly balanced, press the push -
to - talk switch on the microphone. If you get feedback through the
system speakers, adjust the gain on the VM - REMICA until the
feedback is eliminated. See Figure 1 for the location of the gain
adjustment potentiometer.
Specifications
Voltage 21 to 27 VDC
Current 52 mA
Wiring
Type
Audio out
Key out
Resistance
Capacitance
14 to 1 8 AWG (1.0 to 2 .5 mm²) max.,
shielded twisted - pair, in conduit
14 to 1 8 AWG (1.0 to 2 .5 mm²) max.,
twisted - pair, in conduit
210 Ω max.
1 µF
Audio Output 1 VRMS at 400 to 4,000 Hz (4 kHz)
Trouble relay
Current
UL rating
1 A at 30 VDC resistive
Common
Operating environment
Temperature
Relative humidity
32 to 120°F (0 to 49°C)
0 to 93% noncondensing
Regulatory information
Environmental
class
UL: Indoor dry