• Pull the AC QUICK CONNECTOR through the center hole in the mounting plate and
install the mounting plate, making sure that the mounting screws are positioned in
the small ends of the keyholes before tightening the screws (see fig. 2).
• Plug the AC QUICK CONNECTOR into the back of the strobe light, (see fig. 3)
making sure that the locks on the connector snap into place.
To remove AC con-
nector, squeeze locking arm and pull.
• If you have finished all the WIRING AND MOUNTING PLATE MOUNTING STEPS,
you can install the strobe light on the mounting plate. Alignment marks are
provided on the side of the strobe light and mounting plate. With the indicating
marks aligned and rotate the strobe light in the direction of the ON arrow on
the cover until the strobe light snaps in place. (See fig. 4)
• Turn on the AC power. The model SLED177i strobe light has a green AC
power on indicator which should be lit when the strobe is correctly powered.
TAMPER RESIST LOCKING PIN:
To make your strobe light tamper resistant a
locking pin has been provided with your strobe light. Using this pin will help
deter individuals from removing the strobe light from the mounting plate. To use
the pin insert it into the hole in the side of the strobe light after the strobe light
has been installed on the mounting plate (see fig. 5). NOTE: The tamper resist
pin will have to be removed in order to remove the strobe light. This can be
done easily with a long nose pliers. Using the long nose pliers, pull the pin out
of the hole, it is now possible to remove the strobe light from the mounting
plate.
After installation test your strobe light by following the test procedure outlined
in section 6.
Tamper resistant
locking pin
Alignment Marks
FIGURE 3
FIGURE 4
FIGURE 5
Install
Remove
1102-7201-00_Rev.A_EN_V8:_ 2013.5.28 9:45 AM Page 8
