© 2020 Carrier
1 / 4
P/N 3102667-EN • REV 002 • ISS 31AUG20
Genesis LED EG4S Series
Wall Speaker-Strobe
Installation Sheet
Description
Genesis LED EG4S speakers and EG4SV speaker-strobes are wall-
mounted plug-in fire alarm notification appliances designed for indoor
dry applications with 25 or 70 VRMS distributed speaker systems. See
the tables below for a list of models.
Table 1: EG4S speaker models
Catalog number
Description
EG4SRF
Speaker, wall, red, FIRE
EG4SRN
Speaker, wall, red, no marking
EG4SWA
Speaker, wall, white, ALERT
EG4SWF
Speaker, wall, white, FIRE
EG4SWN
Speaker, wall, white, no marking
Table 2: EG4SV speaker-strobe models
Catalog number
Description
EG4SVRF
Speaker-strobe, wall, red, FIRE
EG4SVRN
Speaker-strobe, wall, red, no marking
EG4SVWA
Speaker-strobe, wall, white, ALERT
EG4SVWF
Speaker-strobe, wall, white, FIRE
EG4SVWN
Speaker-strobe, wall, white, no marking
Genesis LED EG4S Series speakers and speaker-strobes feature:
• Field-configurable speaker and strobe outputs. See Figure 2 and
• Enhanced synchronization circuitry to comply with the latest
requirements of UL 1638 and CAN/ULC-S526.
• Input wiring test points on the front of the appliance when the
cover is removed.
• Speakers that are approved for low frequency sounder
applications when used with compatible tone file and systems.
Note:
Synchronized operation requires a separately installed
synchronization device. See the control unit or power supply
compatibility list for compatible synchronization devices.
Configuration
Caution:
Equipment damage hazard. Using excessive force when
removing the appliance cover may damage the cover and prevent it
from latching in place.
To configure the notification appliance:
1. Remove the appliance cover. See Figure 1.
Insert a small, flat-bladed screwdriver into the slot at the bottom of
the appliance.
Gently pull up on the screwdriver to pry the bottom of the
appliance cover down and away from the appliance.
Lift the bottom of the cover out and over the top of the appliance.
2. On speakers and speaker-strobes, set the speaker wattage and
voltage switches for the required values. See Figure 2.
3. On speaker-strobes, set the strobe candela switch for the required
value. See Figure 3.
4. Replace the appliance cover.
Figure 1: Removing and replacing the cover
Figure 2: Speaker switch settings
firealarmresources.com
