2
Power Harness Routing
1. Disconnect negative battery cable from battery.
2. Using a razor knife make a cross shaped incision in the large rubber grommet from inside
the vehicle and feed the power wire from the engine compartment to the cabin. Using a fish
tape wire is recommended. Fig. 1
NOTE: If you are installing the optional amplifier system, install the power wire for it at this
time.
3.
Pull the wire through the grommet until the sheathing touches the grommet.
4.
Remove the fuse box cover under the hood. Remove the fuse from the fuse holder on the
subwoofer power wire and connect the power wire to the accessory lug. Torque to 9 +/-
1.5 Nm. Make sure that the wire exits on the side closest to the battery. Fig. 2
5. Install the black two pin power connector on the subwoofer power harness by first inserting
the terminal fully into the connector and then depressing the blue retainer. Fig. 3
NOTE: Make sure the blue retainer in the center
of the connector is not depressed – it should be
flush with the front of the connector. If the
retainer is depressed, the terminal will not fully
seat in the connector body. Make sure the
terminal is installed into position 1 on the
connector body. There should be a block-out
plug installed in position 2 in order to prevent
the terminal from being installed into the wrong
position on the connector.
Fig. 1
Cut
grommet
here
Fig. 2
Wire
should
exit
in
direction
of
arrow
Fig. 3
Insert
terminal
first
Then
depress
blue
retainer
