Kicker SKM10, Руководство пользователя

Страница: 3 / 12

3
MOUNTING
After determining the best mounting location, and subwoofer fi ring position, carefully check the areas
where the mounting brackets will be placed. Make sure the mounting screws will not puncture the fuel
cell, wiring, or interfere with any mechanical parts on the underside of the mounting surface.
Decide if you want the mounting fl ange positioned under the enclosure or exposed. Attach the two
mounting brackets to the sides of the SKM enclosure using the supplied stainless steel machine screws.
Pre-drill the mounting screw
holes using a 7/64” (2.5mm) bit,
and attach the SKM enclosure
to the boat, by fastening the
supplied stainless steel course-
threaded screws into the mounting
bracket fl ange and into the
boat’s structure. If the supplied
hardware is not applicable to your
installation, some other means of
securely attaching the enclosure
to the vessel must be used.
SAFETY WARNING
To avoid potential injury, or possible death, from forward movement of the enclosure during abrupt stops
or accidents, the enclosure must be properly installed and securely fastened to your vehicle. You are
solely responsible for securely fastening the enclosure in your vehicle.
WIRING
Remove the cover for the speaker terminal cup, plug your
subwoofer speaker wire into the terminals, using the red
connector as positive and the black connector as negative.
Connect the other end of the wire to your subwoofer
amplifi er in accordance with its owner’s manual. Replace
the cover for the speaker terminal cup, by snapping it into
place..
MODEL: SKM10
Nominal Impedance [Zn] | ohms [per enclosure] 4
Power Handling* | Watts Peak [RMS] 300 [150]
Enclosure Depth | in [cm] 8 5/16 [21.1]
Enclosure Height | in [cm] 16 1/16 [40.8]
Enclosure Width | in [cm] 23 15/16 [60.8]
Note: The use of a subsonic fi lter will signifi cantly increase power handling. The power handling specifi cation in this chart
is calculated using a 25Hz, 24dB/octave subsonic fi lter. Kicker Marine speakers use the highest level of magnetic shielding
available to minimize compass and gauge deviation in your dash. Kicker Marine speakers meet or exceed industry standards
for environmental humidity and corrosion, and for material degradation due to UV exposure.
_
SPKR + SPKR -
Mounting Flange exposed
Mounting Flange tucked
under the enclosure
Speaker
Terminal Cup
Cover
*Power Handling Watts RMS without subsonic fi lter: SKM10-125