22. Remove the bolt securing the support brace under the steering column and connect the
subwoofer harness ground wire as shown in Fig. 16. Torque to 8Nm.
23. Locate the 16 pin connector on the amplifier behind the left front speaker housing. Find the
green/brown stripe wire and the gray/brown strip wire in this connector and install one of the
self-stripping t-tap connectors on to each wire. Lay the wire in the open channel, fold the
connector body over and squeeze with a pair of pliers until connector snaps shut. Fig. 17
24. Connect the green wire of the subwoofer harness to the gray/brown strip wire. Connect the
brown wire of the subwoofer harness to the green/brown stripe wire.
25. Connect the ten-pin connector of the harness to the amplifier. Slide the red locking tab
over to prevent the connector from accidentally coming disconnected.
26. Route the harness along the bottom of the front and rear door jam and toward the back seat.
27. Run the wire harness along the floor under the rear seats to approximately the middle of the
vehicle and pull the end of the harness under the seat to the cargo area. Fig. 18
28. Set the subwoofer in place and connect the wire harness.
29. Rotate the rear seat back until it is nearly vertical. While holding the seat back with one hand,
slide the enclosure back until the hooks on the bracket are centered under the anchor points at
the bottom of the seat. Slowly rotate the seat back toward the rear of the vehicle until it locks
into place. Fig. 19
30. Reinstall all previously removed parts in reverse order.
31. Install supplied fuse in the fuse holder under hood.
32. Reconnect the negative battery cable. Torque to 5Nm.
Fig. 19
Fig. 18
Fig. 16
Fig. 17
