9
KX Amplifier
Alternator noise (whining sound that varies with engine
RPM):
Check for damaged RCA cable.
Check routing of RCA cable.
Check source unit for good ground.
Check gain setting, turn down if set too high.
Poor stereo image or reduced bass response:
Check system phasing by turning the balance control
from left to right. If there is more bass output when turned
to either side then check your speaker wiring for proper
positive and negative connections. reverse connections on
one channel if necessary.
CAUTION: When jump starting the vehicle, be sure that
connections made with jumper cables are correct. Improper
connections can result in blown amplifier fuses as well as
failure in other systems in the vehicle.
Help
Please Note: Modern high performance speakers have a lower
DC Resistance than what used to be available. The Kicker
Coaxial and Component Speakers are rated at four ohms (some
DC Resistances may be as low as 3 ohms) and work with any
amplifier designed to operate at a four ohm load. If you want to
use two Kicker Coaxial or Component Speakers on a single
channel of your amplifier wire the speakers in series. This will
improve the sound quality, lower the total harmonic distortion and
lessen the thermal load at the amplifier. This may prevent an
amplifier from shutting down, due to over-current protection
circuitry.
If you have more questions about the installation and operation
of your new KICKER amplifier, see the Authorized KICKER
Dealer in your area. You may also call our Technical Services
Line at (405) 624-8583 for assistance or visit our website at
www.KICKER.com.
NOTE: All specifications and performance figures are subject to change. Please visit the support section at www.kicker.com for the most current information.
Trouble Shooting
