Kicker BX350.1, Руководство пользователя

Страница: 6 / 16

6 BX AMPLIFIERS
TROUBLESHOOTING
If your amplifier does not appear to be working, check the obvious things first such as blown fuses, poor or
incorrect wiring connections, incorrect setting of crossover switch and gain controls, etc. There is a green
POWER LED and a red PROTECTION LED on the end panel of your KICKER BX series amplifier. When the
green LED is lit, this indicates the amplifier is turned on and the amplifier is functioning properly. When the red
LED is lit, this indicates the amplifier is running in protection mode and a problem has occurred.
GREEN LED Light off, no output?
With a Volt Ohm Meter (VOM) check the following:
Œ
+12 volt power
terminal (should read +12V to +16V)

Remote turn-on terminal (should read +12V to +16V)
Ž
Check for
reversed power and ground connections.

Ground terminal, for proper conductivity.

Check for blown fuses.
GREEN LED Light on, no output?
Check the following:
Œ
RCA connections

Test speaker outputs with a
“known” good speaker.
Ž
Substitute source unit with a “known” good source unit.

Check for a signal in the
RCA cable feeding the amplifier with the VOM meter set to measure “AC” voltage.
Protection LED on with loud music? The red LED indicates low battery voltage. Check all the connections
in your vehicle’s charging system. It may be necessary to replace or charge your vehicle’s battery or replace your
vehicle’s alternator.
Protection LED on, no output?
Œ
Amplifier is very hot
=
thermal protection is engaged. Test for proper
impedance at the speaker terminals with a VOM meter (see the diagrams in this manual for minimum
recommended impedance and multiple speaker wiring suggestions). Also check for adequate airflow around
the amplifier.

Amplifier shuts down only while vehicle is running = voltage protection circuitry is engaged.
Voltage to the amplifier is not within the 10–16 volt operating range. Have the vehicle’s charging and electrical
system inspected.
Ž
Amplifier will only play at low volume levels = short circuit protection is engaged. Check
for speaker wires shorted to each other or to the vehicle chassis. Check for damaged speakers or speaker(s)
operating below the minimum recommended impedance.
BXRC REMOTE BASS INSTALLATION
mount the housing
phone cable