3. CHANGING SWITCH HOUSINGS AND
COMPONENTS
ATTENTION:
The CoolTouch™ Control System requires the
purchase of a new Switch Housing that will replace your existing
Switch Housing. Part number 370017 or 370018 depending on the
mounting plate diameter. Available in a finish to match your ceiling
fan.
1. Loosen the four (4) mounting screws located around the top edge
of the switch housing.
2. Rotate the switch housing until the mount screw heads are at the
"open" end of the key hole slots and pull the switch housing
downward. See Figure G as needed.
3. Locate the small plastic clip on the side of the square wire
connector. While pressing to hold the clip open, pull the wire
connectors apart.
4. You have remove the existing switch housing from your ceiling
fan. You won't be needing it with your new remote control
installation.
It's suggested that you keep this original switch housing and all
components inside just in case you decide to remove the
CoolTouch™ Control System at a later date.
5. Locate your NEW empty switch housing and place the
CoolTouch™ Wiring Harness inside. (Fig. H)
Fig. G
Fig. H
Switch
housing
Wire connector
Screws
Mounting plate
Reverse
module
Wiring
harness
Empty switch
housing
Capacitor
Receiver to Supply Wires: Figure F
Green fan wire to............................................Bare (copper) supply wire
Black receiver wire marked
AC In L
to........ Black supply wire
White receiver wire marked
AC In N
to........White supply wire
Receiver to Fan wires: Figure E
White receiver wire marked
TO MOTOR N
to..............White wire from the Fan
Black receiver wire marked
TO MOTOR L
to...............Black wire from the Fan
Blue receiver wire marked
FOR LIGHT
to.....................Blue wire from the Fan
Orange receiver wire marked
FOR UPPER LIGHT
to......Orange wire from the Fan
Fig. F
AC SUPPLY
BLACK
WHITE
ORANGE
ORANGE
BARE
GREEN
WHITE
WHITE
BLUE
BLUE
BLACK
BLACK
WHITE
BLACK
RECEIVER
OUTLET BOX
NOTE:
Some ceiling fans are not equipped with a Downlight or
accent Uplight. The Blue wire on this receiver is for a Downlight
and the Orange wire is for a accent Uplight. If your ceiling fan
does not have either one or both types of lights, USE A WIRE
NUT AND CAP OFF THE WIRE(S) NOT USED.
CAUTION:
If the household supply wires are a different color
than described here, it's recommended that you have a qualified
electrician make these connections.
d. Push all connected wires up into junction box.
e. Reinstall the canopy on the mounting bracket. (Fig. C)
CoolTouch
TM
control system
2
