1
1. SAFETY RULES
WARNING! RISK OF ELECTRIC SHOCK
"CAUTION-RISK OF FIRE"
Fig. 2
2. INSTALLING THE LIGHT KIT
All electrical connections must be in accordance
with local codes, ordinances, or national codes,
ANSI / NFPA 70-1999. If you are unfamiliar with
methods of installing electrical wiring, secure the
services of a qualified electrician.Before starting
installation, disconnect the power by turning off the
circuit breaker or removing the fuse at fuse block.
Turning power off using fan switch (speed control
on/off) is not sufficient to prevent electrical shock.
NOTE: The important safeguards and instructions
appearing in this manual are not meant to cover all
possible conditions and situations that may occur.
It must be understood that common sense, cau-
tion and care are factors which cannot be built into
any product. These factors must be supplied by
the person(s) caring for and operating the unit.
Step 1. Remove the hex nut (1) and finial located
in the bottom of the switch cover by using a tooling.
(Fig. 1) Keep them for future use.
Step 3. Connect the BLACK wire connectors from
the light fixture and switch housing by pushing them
together. Follow the same procedure with the
WHITE wire connectors. (Fig. 2)
Step 2. Feed the electrical wires from the light
fixture through the holes in the middle of the rubber
washer and switch cover (starting with one by one).
Threaded the light fixture onto the switch cover and
make sure the pull chain hole on the switch cover is
nearest to the one of light fixture and pass it into the
hole. Add the lock washer and hex nut (2) onto the
inside of the switch cover and tighten securely.
(Fig. 2)
Fig. 1
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DISCONNECT THE ELECTRI-
CAL SUPPLY CIRCUIT TO THE FAN
BEFORE INSTALLING LIGHT KIT. CON-
SULT A QUALIFIED ELECTRICIAN TO
ENSURE CORRECT BRANCH CIRCUIT
CONDUCTOR.
Switch Cover
Finial
Hex Nut (1)
Hex Nut (2)
Lock Washer
Switch Cover
Light Fixture
Rubber Washer
