3. OPERATING TRANSMITTER:
A.
Install 1 x
9V
battery (included). To prevent damage to transmitter,
remove the battery if not used for long periods. (Figure E)
B.
Store the transmitter away from excess heat or humidity.
C.
This remote control unit is equipped with 16 frequency code
combinations to prevent possible interference from or to other remote
units such as garage door openers, car alarm or security system. If you
find that your fan and light kit go on and off without using your remote
control, simply change the combination code in your transmitter and
receiver.
D.
Operation buttons on the panel of the transmitter: (Figure F)
The
" HI, MED, LOW"
buttons:
These three buttons are used to set the fan speed as follows:
LOW
= Low speed
MED
= Medium speed
HI
= High speed
The
"OFF"
button:
This button turns the fan MOTOR off.
The
"
"
button:
This button controls the light brightness and will turn the light on or off.
The light function is controlled by pressing the " " key. Hold the key
down to increase or decrease the light. Tap the key quickly to turn the
light off or on. If you press the button in excess of 0.7 seconds it
becomes a dimmer. The light varies cyclically in 0.8 seconds. The light
key has auto resume, so it will stay at the same brightness as the last
time it was turned off.
YOUR REMOTE NOW HAS FULL CONTROL OF THE FAN AND
LIGHT.
4. TROUBLESHOOTING GUIDE
If the Ceiling Fan and or light fixture(s) fail to respond to commands
from the transmitter, check the following.
● Check the main power supply and reset or turn on the breaker.
● Make sure the "Receiver Unit" is wired properly.
● Light Fixture pull chain switch turned to ON ?
● Make sure the speed pull chain is set to the HIGHEST speed.
● Good batteries in transmitter ? Replace if needed.
● Transmitter and Receiver "frequency" switches set to match each other ?
NOTE:
The distance between the transmitter and receiver should not be
greater than 30 feet. For best performance, make sure the Black
Antenna on the end of the receiver unit remains extended and not
tangled with any of the electrical wires.
WARNING:
This control system is intended for use on 120 volt / 60Hz
power systems ONLY.
WARNING:
The dimming function on this control system is NOT intended
for use with NON-Dimmable Fluorescent lamps.
Fig. E
Fig. F
If any of the fan or supply wires are a different color, have this unit
installed by a qualified electrician.
e. Push all connected wires up into junction box.
f.
Reinstall the canopy on the mounting bracket.
g. Restore the electrical power.
2
