Kia Sorento 2018, Руководство по функциям и возможностям, Страница: 42 / 54

SORENTO
F E A T U R E S & F U N C T I O N S G U I D E
40
*IF EQUIPPED
Erasing programmed buttons:
How to Sync Transmitter with HomeLink ® *
If programming for the first time, begin with Step 1 (repeating this step will
delete all information) .
To program non-rolling and rolling code garage door openers and other
devices:
1 . Press and hold the left A and center D buttons simultaneously until the
indicator light C begins to flash (to reprogram buttons, skip this step)
2 . Press and hold the desired button A B D and hold the button on the
transmitter while it is approximately 1 to 3 inches away from the mirror .
The HomeLink
®
Indicator light C will flash rapidly once the frequency
signal has been successfully programmed
To finish programming rolling code garage door openers, complete these
steps:
3 . Locate the “learn” or “smart” button on the garage door’s motor head
unit . Press and release the button and complete Step 4 within 30 seconds
4 . Firmly press and release the programmed HomeLink
®
button up to three
times
Press and hold the left A and center D buttons simultaneously for
approximately 20 seconds, and then release both buttons within 30 seconds .
Operating HomeLink
®
:
Press one of the programmed HomeLink ® buttons .
REMINDER: Mirror indicator light
C
will illuminate when automatic dimming is ON .
If your garage door opener was manufactured in 2011 or later, and you’re unable to program
your vehicle’s HomeLink
®
system, you may need to purchase a HomeLink Repeater Kit. For more
information, go to www.HomeLink.com or call (800) 355-3515.
The HomeLink
®
/ Auto-Dimming Rearview Mirror* is designed to
reduce glare from a vehicle’s headlights located in the rear and also
connect up to three electronic transmitters into one location .
•
To turn automatic dimming ON, press button F
•
To turn automatic dimming OFF, press button G
HomeLink
®
with Auto-Dimming Rearview Mirror*
A HomeLink ® button
B HomeLink
®
button
C Indicator light
D HomeLink
®
button
E Glare detection sensor
F Automatic dimming ON
G Automatic dimming OFF
A B C D E F G
•
•
You can reprogram a single HomeLink ® button by repeating Step 2
•
Erasing programmed buttons will delete all trained transmitters
QUICK TIPS
OTHER KEY FEATURES