USB Ports and Use of Cables
Vehicle may contain USB port(s) for playing music from a compatible media device as well as USB port(s) for charging. Note: devices
will only be recharged when the vehicle is in ACC/ON/Start position. If you encounter difficulty plugging in a USB device, change
the orientation of the device (may be upside down). Always use the USB charging cable that has been certified by the device
manufacturer. Use of aftermarket cables is
NOT
recommended as they may impact functionality.
Windshield Defogging
B
A
Windshield fogging is caused by moisture in the air condensing on the cold
glass. The following practices can help reduce window fogging:
• Keeping the inside of the glass as clean as possible.
• Utilizing the Defrost Mode activates the A/C and opens Fresh Air Vent (A).
• Adjusting the Temperature Control to the desired temperature (B).
Seat Warmers / Ventilated Seats*
5
(Buttons located below Gear Shift)
(Type A shown)
Warming
(Yellow LED)
Ventilating (Blue LED)
• Press bottom (ventilate) / top (warm) of button once for high setting (3 LEDs lit).
• Press twice for medium setting (2 LEDs lit).
• Press a third time for low setting (1 LED lit) and again to turn OFF.
Driver Position Memory System*
6
A
B
To store a seating position into memory, first place the gear shift into P (Park) while the ENGINE START/
STOP button is ON. Then:
1. Adjust the driver’s seat and outside mirrors.
2. Press the SET button (A) on the control panel. The system will beep once.
3. Press one of the memory buttons (B) within 5 seconds. The system will beep twice when memory
has been stored.
4. ‟Driver (1 or 2) set is memorized” will appear on the instrument cluster LCD display.
Images or graphics for illustration only.
*If equipped. 1. The driver’s primary responsibility is in the safe and legal operation of a vehicle, and use of any handheld devices, other equipment
or vehicle systems which take the driver’s focus away from the safe operation of a vehicle or that are not permissible by law should never be used during operation of the vehicle. 2. The
Bluetooth
®
word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Kia is under license. A Bluetooth
®
enabled cell phone is required
to use Bluetooth
®
Wireless Technology. 3. Apple CarPlay, iPhone and Siri are registered trademarks of Apple Inc. Android and Android Auto are trademarks of Google LLC. 4. Driver-assist
technologies are not substitutes for safe driving, and may not detect all objects surrounding vehicle. Always drive safely and use caution. 5. Use extreme caution when using the seat
warmers to avoid burns. Refer to the Owner’s Manual for more safety information. 6. Do not adjust the seating position while driving as this may cause you to lose control of the vehicle.
Check Engine Light from Fuel Cap
C
L I
C K !
Tighten the cap until it clicks one time; otherwise, the Check Engine Light
may illuminate.
The Fuel Filler Door Release button is located on the driver’s panel, left of the
steering wheel.
Blind-Spot Collision Warning (BCW)*
4
A
The BCW system uses radar sensors to detect vehicles in the blind spot, and alerts the driver before
changing lanes. The light on the BCW button (A) will illuminate when turned ON. The outside rearview
mirror warning lights will also illuminate for 3 seconds.
The system will become active when the vehicle is traveling faster than 18 mph and, under certain
conditions, will alert the driver if another vehicle is detected by the radar sensors.
Parking Distance Warning–Forward* and Reverse*
4
The Parking Distance Warning–Forward* and Reverse* is a supplemental system that is designed to assist
the driver by chiming if any object is detected within the sensing area to the front, rear and side of the
vehicle when moving forward or backing up.
Forward Collision-Avoidance Assist-Pedestrian (FCA-Ped) / Forward Collision Warning (FCW)*
4
FCA-Ped is designed to help alert the driver and, under certain conditions, apply emergency braking when
rapidly approaching a vehicle that is slowing down, braking or stopped. Initially, the FCA-Ped provides
Forward Collision Warning (FCW) when it detects a potential collision with a vehicle in front emitting an
audible warning and visual alert on the instrument cluster. Adjust the alert settings (Early, Normal, Late)
in the instrument cluster. To turn the FCA-Ped / FCW off, go to User Settings again and turn off. If the
system detects possible imminent collision, under certain conditions, Forward Collision-Avoidance Assist-
Pedestrian (FCA-Ped) automatically applies the brakes to reduce your speed, helping to minimize the
effects of a possible collision. FCA-Ped can be turned ON in the User Settings menu on the Instrument
Cluster display.
FCA-Ped / FCW will become active when the:
• Engine Start/Stop button is ON
• Vehicle is traveling faster than 5 mph
• Electronic Stability Control (ESC) is ON